Previous Thread
The last time I had MediaMonkey installed it recognized the storage on the player and the card as separate locations. It does not realize that once the Fuze is full it can start using the card because it sees it as a separate drive.
I think you have to take care of this manually.
Just purchased a 4gb Fuse and am trying to set it up using MediaMonkey (MM). After converting my .m4a files to mp3's all my music seemed to load fine on the Fuse, until I maxed out the 4GB storage. I have added a 8GB SDHC card but no data is being added to the card.
How can I have the data also added to the SD card during syncing?
April 12, 2009 10:58 AM
Add Your Reply
Sponsored Links
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
Sansa™ is a trademark of SanDisk Corporation. SansaCommunity.com is not affiliated with SanDisk Corporation.
