Previous Thread
Could you please tell me how you managed to get the 'bin file' to sort out this volume problem.I'm not very technical so an easy explanation would be appreciated.I've just put new firmware on my fuse and am infuriated that the volume is so low!!! thanks v much
Hi i up dated the firmware on my 8 GB fuse to 1.02.31F and am not happy with the out put volume.I wish i had looked in to this before i did it................
According to Sann disk its cos of an E.U law of only allowing 85 decibles max volume.
Is there anyway to roll back the firmware to an earlier version or some sort of fix.
February 1, 2011 10:34 AM
It was some time ago that i had this problem but i think i found what i needed here.
http://www.sansacommunity.com/blog/entry/11635/Sansa-Fuze-Firmware-Update/
i cant check which firmware my fuse is using as i am recording on it for the next 3 hours, also in the settings on the fuse you can select 2 different volume settings if i remember correctly ( i may be wrong......)
Hope this helps.
Add Your Reply
Sponsored Links
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
Sansa™ is a trademark of SanDisk Corporation. SansaCommunity.com is not affiliated with SanDisk Corporation.
Its ok i managed to find a bin file with an older version of the firmware than the update i did and think its ok now.